How to Hard Reset Your Router

Hard reset TP-LINK TL-WPA4220

by

Posted on July 25th, 2014


TP-LINK TL-WPA4220
Factory reset (Hard reset) The device should be turned ON. The reset button is the small hole on the bottom of the device /see the picture above/. Press in it with a paperclip or a pin and hold for a bit more than 5 full seconds then release. Wait until you see all the LEDs flashing - that means the default settings have been restored.
Specifications
Manual
Firmware Link to support
Default username admin
Default password admin
Default IP address 192.168.1.1

Similar routers from TP-LINK: