How to Hard Reset Your Router

Hard reset TP-LINK TL-MR3220

by

Posted on August 21st, 2013


TP-LINK TL-MR3220
Factory reset (Hard reset) Power ON the router. Locate the reset button (or hole) on the rear panel - it should be labeled WPS/RESET or just RESET. Press the button for about 5 seconds - the SYS LED should start blinking faster. When this happens - release the button. If 5 seconds are not enough - try holding the button down for 8 seconds.



PS. For older versions of this model you might need a thin object to press into the button hole - try using a paperclip.
Firmware Link to support
Default username admin
Default password admin
Default IP address 192.168.0.1 or 192.168.1.1

Similar routers from TP-LINK: